Electricity is one of the most essential resources that power modern life. As energy demand continues to increase, society must focus on optimizing its usage to minimize waste and lessen the environmental impact. Fortunately, Setra's Multi-load Power Metersprovidea simplified solution to this growing problem. Through submetering, these meters help facilities monitor and manage their electricity consumption more effectively, identifying potential sources of waste and enabling greater energy efficiency.
February 24, 2022
Buildings have a considerable impact on the environment, using energy and other resources while generating potentially harmful waste. To reduce this impact, green building standards now encourage sustainable design. Although a building can be green without receiving green building certification, there are many benefits accompanying this certification.
January 06, 2022
Setra Systems will be exhibiting at the AHR Expo in Las Vegas from January 31 through February 2. In addition to our extensive HVAC and Critical Environments lines, this year Setra will be unveiling several new and exciting products. Come by and see Setra at booth C5712!
September 09, 2021
Unlike the 32-bit addresses of IPv4, IPv6 addresses are 128-bits. These longer addresses are partitioned into 16-bit bocks; then, each of these smaller blocks is turned into a 4-digit Hexadecimal number. Built into IPv6 addresses is notation identifying the application it will be used for. The first 64-bits of the address are for routing and the last 64-bits represent the interface or node.
August 26, 2021
Setra is pleased to announce that the industry’s most versatile power meter just got better! In addition to the flexible installation, intuitive configuration portal, and unparalleled accuracy, the already versatile communication selections have just been expanded. All SPM Series power meters now support Internet Protocol version 6 (IPv6) & supports BACnet addendum 135-2012aj, which covers the BACnet/IPv6 section of the standard.
June 17, 2021
ASHRAE 90.1 is a standard for measuring energy in commercial buildings. It covers many aspects of energy management, such as total consumption, HVAC and lighting systems, and individual circuits. For buildings over 10,000 square feet, with or without tenants, it is more cost effective to have multi-load, branch circuit, and high-density monitoring equipment. In buildings with tenants, both individual and total building usage need to be monitored every 15 minutes at a minimum and be recorded hourly, daily, monthly, and annually.
June 10, 2021
IPv6 is the most recent version of the Internet Protocol (IP), the communications protocol that provides an identification and location system for computers. First developed by the Internet Engineering Task Force in the 1990s, IPv6 became a full standard in 2017. However, its spread and usage in the world has not been as fast as anticipated. In 2012, IPv6 was permanently enabled by Internet Service Providers, networking equipment manufacturers, and web companies.
October 06, 2020
To effectively manage energy consumption and develop plans for cost savings, it is crucial to understand your electric bill. Once you understand your electric bill, you can leverage that information to make changes to electrical consumption and ultimately save money.
September 22, 2020
Power meters are used in a wide variety of applications to measure electricity use on a more granular level than the main utility meter. Power meters, or submeters as they can sometimes be referred to as, can tell you where, how, and how much electricity is being used in the building.
September 15, 2020
Revenue grade power meters are defined in the American National Standards Institute (ANSI) standard C12.20-2010 Class 0.2. The intention of such a standard is to establish the requirements for power meters so the meters in question accurately and reliably provide monitoring. This ANSI standard has 3 accuracy classes: 0.1, 0.2, and 0.5. These classes correspond to accuracy at full load and include CTs.